Short answer: weak or no vapour comes from one of four things. The battery is low, the tank is empty, the airflow is blocked, or the draw sensor is not triggering. The light or screen tells you which.

Read the light first

When you draw Likely cause
Light comes on, vapour is thin and flavour is weak Low battery or nearly empty tank
Light comes on, no vapour at all, draw feels blocked Blocked airflow
Light comes on, no vapour, draw feels normal Empty tank or failed coil
Light blinks Flat battery or a cut-off. See vape light blinking
No light at all Flat battery, seal still on, or sensor not triggering

Low battery

As the battery runs down it delivers less power, so the coil runs cooler and makes less vapour. If the device has a USB-C port, charge it and compare. A clear improvement confirms it.

Nearly empty tank

Vapour and flavour both fade over a day or so, then puffs start to taste dry or burnt. On devices with a display, the e-liquid reading will be at or near zero.

Blocked airflow

If drawing feels like sucking on a blocked straw, something is in the way. Check that the mouthpiece plug and the base sticker are off, then clear lint from both ends. More in draw too tight.

Sensor not triggering

Draw-activated devices fire when a small sensor feels airflow. It can miss very soft puffs, and it stops working if e-liquid has run onto it.

  • Take one firm, steady puff.
  • Cover the base air inlet with a finger for half a second as you start to draw, then release.
  • If the device has leaked or gurgles, stand it upright for an hour and try again.

Cold weather

Cold e-liquid is thick and wicks slowly, and a cold battery gives less power. Both reduce vapour. Warm the device in a pocket for ten minutes.

Wrong mode

On devices with two power modes, such as IGET One and Bi Bubble Graffiti, Normal makes noticeably less vapour than Turbo. Check which one is selected.

When to stop using it

A device that makes no vapour is usually just empty or flat. But stop using it and do not charge it if it is hot while idle, swollen, hissing or has been in water. The full list of warning signs and how to get rid of the device safely: when to stop using a vape.

Frequently asked questions

Why is my vape not hitting but the light is on?

Power is reaching the board but not making vapour: the tank is empty, the airflow is blocked or the coil has failed. Check the e-liquid level and clear both ends first.

Why is my vape producing less vapour than before?

Usually a low battery or a tank that is running out. Recharge it if you can. If vapour stays thin and the flavour is fading, the device is nearly empty.

Why does my new vape not hit?

Look for a plug in the mouthpiece and a sticker over the air inlet on the base. Then charge it for 20 minutes if it has a port.

Does cold weather affect vapour?

Yes. Cold thickens the e-liquid and weakens the battery. Vapour returns once the device warms up.

More vape troubleshooting

Not sure the device is empty rather than faulty? See how long a disposable vape lasts. Shopping for a replacement? Browse disposable vapes or compare the lines in disposables compared.